Build Trays
FAQ
Build tray options
There are multiple options available when choosing a build tray for your printer.
Asiga build trays are available in the following configurations:
- 1 liter
- 2 liter
- 5 liter
- 10 liter
Build trays have a set lifespan programmed into them. This is controlled by the RFID tag on the back of each tray.
Why do build trays expire?
Asiga build trays are built with a flexible membrane to house resin during the printing process.
This membrane is subject to wear&tear during the printing process and stretches over time.
If the build tray becomes damaged, it may cause a resin spill or worse – damage to your printer.
To prevent unwanted spills or damage, Asiga programs the build trays to stop working when their intended lifecycle has been reached.
Caring for the build tray
To ensure your build tray works for it intended lifecycle, please follow the below video when you have a print failure.
Print failures can cause debris in the build tray. This debris can puncture the tray causing a resin spill.
Storage
When the build tray is not in use it’s best practice to keep it stored away in a dark environment away from potential contaminates.
Asiga offers an affordable solution for this that allows you to stack build trays.
Check with your reseller about our Build Tray Containers.
Build tray lifetime monitoring
How do you know when a build tray is about to expire?
Each time a new print is submitted, the printer will automatically read the RFID tag on the tray.
You can check the usage and other information of your current tray by following these steps:
- Select System from the Main Menu
- Select Tray Data
When the build trage usage reaches 100%, the tray will automatically stop working.
Disposing of or replacing the build tray
Uncured resin is classified as hazardous to aquatic life.
When the build tray has reached 100%, it must be replaced.
Old build trays contain uncured resin that must be dealt with according to local laws.
Please place the build tray in direct sunlight or a UV chamber until all the remaining resin has cured.
How do you change the build tray on your MAX?
How do you change the build tray on your PRO 4K?
